You are not logged in.
Pages: 1
Hi Q4OS'ers!
On my NEC EA244WMi it's not possible to install Q4OS because the monitor won't run in such low resolution as the installer screen
I tried connecting a lower res monitor to do the install but then when restarting post-install and connecting up the NEC I also got "Out of Range" message [usually indicating too low a res]
Any tips on how to combat this?
Thanks!
We cannot solve our problems with the same thinking we used when we created them.
Offline
I have had similar problems (a long time ago though) and found I had the wrong type of vga lead, and also had a quick look at specs and noticed it has DVI-D connector which might also require a specific connecting lead. Which connection port are you using?
Offline
The NEC monitor has Graphics Port, HDMI, DVI and VGA [so everything!]
I am using HDMI for the RPi
The main PC is on VGA because I have never gotten round to getting a better lead
I plugged in a crappy monitor to do the install etc and made sure I could log into a GUI
After that I plugged the better monitor and all working
Last edited by cpcnw (2018-08-06 11:10)
We cannot solve our problems with the same thinking we used when we created them.
Offline
Good news! still a bit strange the NEC wouldn't allow a viewable screen though
Offline
According to a guy at a local computer store this is common with recent hi res monitors...
We cannot solve our problems with the same thinking we used when we created them.
Offline
Yes, I think the advance in screen sizes and resolution has caused a few issues although as they are becoming much more common I would hope this becomes less of an issue.
Offline
Pages: 1