You are not logged in.

#1 2019-09-15 08:20

serhii
Member
Registered: 2019-09-15
Posts: 1

Q4OS 3.8 doesn't boot after installation

System freezes on stage when booting:
...
[ OK ] Found device SAMSUNG_HM251HI 6.
[ OK ] Found device SAMSUNG_HM251HI 7.
          Starting File System Check on /dev/disk/by-uuid/7f176c7b-4ed5-4ace-b643-5a77e506acf5...
[ OK ] Created slice system-systemmd\x2dbacklight.slice.
          Starting Load/Save Screen Backlight Brigthness of leds:dell::kbd_backlight...
          Starting Load/Save Screen Backlight Brightness of backlighte:acpi_video0...
          Activating swap /dev/disk/by-uuid/1bc68ba6-6392-4a14-80cc-6f24c755d24f...
[ OK ] Started Load/Save Screen Backlight Brightness of backlight:acpi_video0.
[ OK ] Started System Check Daemon to report status.


What's problem can be here?

Dell Inspiron 1018
Intel Atom N455/ RAM 2 Gb / HDD 250 Gb / Intel GMA 3150

Offline

#2 2019-09-20 04:36

!Tommy
Member
Registered: 2018-02-13
Posts: 3

Re: Q4OS 3.8 doesn't boot after installation

I'm having an issue booting into Q4OS 3.8 as well. Mine hangs after a cursor shows up after the tty1 screen disappeared. I've left it on that screen for quite a long time to see if eventually it would boot, but it did not unfortunately. Q4OS 2.6 works just fine, no issues whatsoever.

I have a Dell Inspiron 1525 laptop. Maybe there's a setting in the BIOS that it doesn't like?

Last edited by !Tommy (2019-09-20 04:37)

Offline

Board footer

Powered by FluxBB